Large Solenoid Voltage Connector

$10.11
In stock
SKU
W_635
Add to Wish List
 

The female voltage terminal slots are spaced at 19 mm from left (1) to right (2) and the center ground wire terminal slot (⏚) is 7 mm above these. The inner core can be removed and rotated to facilitate the position of the terminal slots in the desired orientation.

Removal:

Loosen the fixing screw holding the original connector to the solenoid. Remove the connector from the solenoid coil. Remove the rubber moisture protector. Loosen and draw back the wire restraint nut. Using a small straight screw driver, gently pry the center insert out (there is a small slot to insert the screwdriver into). Note the position and placement of your original wiring (wire color and if left or right of ground) and write it down or take a picture. Loosen the small wire fixing screws on the insert. Remove the original insert, body and wire restaint nut.

Replacement:

Feed the wires through the center of the new wire restraint nut and in to and through the body of the connector. Pull as much wire as is needed to comfortably be able to secure the wires with the small screws on the inside of the new insert. Secure the wires in their original position with the small screws. Draw the wiring back out of the connector at the same time as you press the insert back into place, noting that the ground terminal slot is also in it's original orientation. Slide the wire restraint back to the body and tighten it down. Replace the moisture protector. Press the connector back on to the solenoid coil and tighten the fixing screw.

When used on a Fluid-o-Tech vibratory pump, there is a small diode inside the connector: FR306 DC or FR307 on terminals 2 and 3. This diode is not included with this part, nor do we have a source for it.

Espresso Parts Guarantee:

We guarantee a full refund or replacement of all defective products at no additional cost to you. Most electrical items have specified limited warranties. If an electrical device fails to function due to manufacturers defect, Espresso Parts will repair or replace the device (TBD).*Important Note: All Special Order Items, Equipment, Electrical Items (scales), Pump Heads, Solenoids, Custom Work and Books are NOT eligible for return. All sales are final on this merchandise. Learn more on our return policy page
 
If you have any questions or need assistance we have an awesome customer support team that would love to help you! Please call us! 1-800-459-5594 or email info@espressoparts.com
 
More Information
SKU W_635
Manufacturer LF

5.00 Average

4 Reviews

Mark B.

Replaced OEM connectors on Wega EVD 2. Perfect fit to 3 pin Parker solenoids. Includes rubber gasket missing on OEM. Good addition in damp environment.

Alexander

As stated doesn't come with diode or wires. If you call up fluid-o-tech you can order all the stuff you need so that you don't have to worry about wiring up a diode. They also have different mounts for the pump.

Louis

Quick easy install perfec fit ! Thick plastic housing Scew terminals

ED

This is a 3 pin connector but fit my Nuova Simonelli Aurelia 3 pin electrovalves. Also looks the same inside as the original connectors except they are 4 pin. One unused pin.