Details
Solenoid Voltage Connector
A voltage connector for solenoid coil wiring. Not the same as the flowmeter connector (V_377), the terminal spacing is different. The inner core can be removed and rotated to position the terminal slots as needed.
SPECIFICATIONS
- Terminal slot spacing: 12 mm
- Ground wire slot: 12 mm above terminal slots
COMPATIBILITY
- Works with: solenoid coil wiring
- Not interchangeable with the flowmeter connector (V_377), different terminal spacing
INSTALLATION
Moderate DIY, loosen the fixing screw, remove the connector and moisture protector from the coil, draw back the wire restraint nut, gently pry out the center insert, note your original wire color and position relative to the ground slot, then reverse the process to install the new connector.
PRO TIPS
- Before disconnecting the old connector, photograph or note which wire color sits on which side of the ground terminal slot, the replacement insert needs to go back in the same orientation or you'll cross the wiring.
- Don't confuse this with the flowmeter connector (V_377), the terminal spacing is different (12 mm here vs. 9.5 mm there), so the two aren't interchangeable even though they look similar.
Customer Reviews
Attention CA Residents: Prop 65 Warning
WARNING: This product can expose you to chemicals including lead, which are known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information, go to www.p65warnings.ca.gov.