Everpure E-10, 10" Coarse Prefilter System
E-Series prefilters (previously clear - now black) are designed to increase the life of Everpure carbon water filters in areas with an unusual amount of dirt in the water. With a 10 micron (nominal) rating, the Everpure prefilter traps much of the dirt which contributes to scale buildup in ice makers, and clogs the delicate orifices of other water-using equipment.
The standard EC110 Cartridge is provided with each Model E10 Filter. It is rated at 10 microns nominally and has a more-than-adequate life when filtering water with "normal" or average dirt loads.
APPLICATIONS AND FEATURES
- General purpose coarse filtration
- Pre-filtration for fine filters
- Reduces dirt, rust, oxidized iron sulfide
- High-strength materials
Head has 3/4" female pipe threads (also includes reduction adaptor fittings for 1/2" FNPT or 3/8" FNPT) for inlet and outlet pipe connections: it is constructed of polypropylene. Dirt/Rust cartridges are graded density spool type, with synthetic materials.
The factory spec sheet can be downloaded here
Prefilter System for foodservice applications
NOTE: The contaminants or other substances removed or reduced by this drinking water system are not necessarily in your water. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used with disinfected water that may contain filterable cysts.
H: 12.44” W: 5.16 D: 5.5”
Choose a mounting location suitable to support the full weight of the system when operating. Make sure to properly lubricate o-ring prior to use. Use 3/4" water line (optional reducer bushings included). Install vertically with bowl hanging down. Allow 2-1 ⁄2" (6.35 cm) clearance below the cartridge for easy cartridge replacement.
IMPORTANT: Always use a NSF approved pipe dope or PTFE plumbers tape at all thread connections.
|Size||Short (10 cm)|